CCIE Dumps CCIE Dumps CCIE Dumps CCIE Dumps CCIE Dumps CCIE Dumps CCIE Dumps
Four steps teach you how to use SecureCRT to connect to eNSP!
1 The first step is to obtain the Local Server information of the device.
Information can be found in the following paths: Menu & LT; Tools & lt; Option & lt; Server Settings
As shown in the figure above, the default LocalServer IP is 127.0.0.1, which you can change.
2There are two ways to find the COM port information provided by the device.
Right-click the desired device: Settings & LT; You can view the port number of the device
Click the arrow on the right of the simulator to view the COM port information of the device
3
Try using SecureCRT to link the AR1 device. Open CRT using Quick Connect, select Telnet login, enter LocalServer address and COM port information.
Here is an example of a successful login:
4
Finally, run the configuration command to check whether the connection is normal.
If the connection is successful, you can see the sent command through CRT.
Four steps teach you how to use SecureCRT to connect to eNSP!
CCIE Dumps CCIE Dumps CCIE Dumps CCIE Dumps CCIE Dumps CCIE Dumps CCIE Dumps
